Pole Base is made by quality manufacturers throughout North America. Enter your location below, and we'll provide you contact info for the person who can answer questions about Pole Base near you. It's that easy. Reach out when you're ready!
Installing Pole Base is simple so you can focus on the aspect of your job that you love - getting the lights turned on. The concrete work is complete, so you can set the base as soon as it arrives on the jobsite. Watch the video or read below to see how Pole Base installation is easy as 1, 2, 3!
Typical cast-in-place concrete pole base foundations not only require good weather conditions to install, they also require a lot of time and steps. Check out how easy it is to install Pole Base where you simply auger, place, and backfill. Why not remove all those other steps and have the bases delivered ready to go?
Determine the location for placement of the Pole Base, then auger or open cut a hole in the position you need the base. Next, place a 6-inch (152-millimeter) foundation of crushed stone in the bottom of the hole. This will ensure that the base stays in place over time.
To place your Pole Base in the hole, connect a lifting device to the base, then lower the base using a piece of machinery. An excavator will do the trick. Now, adjust and level the base, then run the wire and conduit.
Next, backfill around the base. If it's an excavated hole, backfill and compact in about 6-inch (152-millimeter) lifts using a standard compactor. You can finish around the base by paving, or placing topsoil and spread seed or sod. The base is ready, so the poles and lighting can be mounted and turned on immediately!
Enter your location below, and we'll provide you contact info for the person who can answer questions about Pole Base near you. It's that easy. Reach out when you're ready!